- Quick Start Guide for Gen1 S1070/S1080/S1090
- Pairing with the ASAHOM App
- Cutting & Reconnecting for Gen1 Waterproof Junction Box
- LED number setting for Gen1 Controller
- Cutting & Reconnecting for Gen 2 Waterproof Junction Box
- Quick Start Guide for Gen2 S1070/S1080/S2080
- Layout Setting for Gen2 Controller
- How to connect to Ethernet (Gen 2 S1080 S2080 only)
- Power extension cord
- Gen 1 T-splitter
- Power-T Connector
- Wire Clip / Screw Pack
- End Cap
- Gen 1 Waterproof Junction Box
- Wall-Mount Enclosure Kit
- Track-Mount Kit
- Gen 1 Light string extension cord
- Gen 1 Controller
- Fault Detection Module
- Gen 2 T-Splitter
- Gen 2 Waterproof Junction Box
- Gen 2 Light string extension cord
- Gen 2 Controller
- Dual Output vs. Single Output: Unlock Greater Flexibility for Your Permanent Outdoor Lights
- Why ASAHOM Permanent Outdoor Light Installations Over 200ft Need Extra Power Injection?
- The Simple, Secure Seal: Why ASAHOM's Waterproof Connectors Are a Game-Changer
- Unleash Your Creativity: How ASAHOM's Palette & Effect Combo Redefines Smart Lighting
- Why Your Outdoor Lights Stay Connected: The Truth About WiFi & Why ASAHOM Uses 2.4GHz
- Beyond Simple Splitting: How the ASAHOM T-Splitter Redefines Smart Lighting Control
- Redefine Your Night: The Power of Zone Control with ASAHOM
End Cap
What is the End Cap?
The End Cap is a small waterproof accessory designed to seal the cut end of your light string after trimming. It prevents water and dust from entering the exposed wiring, ensuring long-term durability of your outdoor lights.
When to Use the End Cap?
After trimming off extra lights at the end of your eaves.
When there are unused sections of light string that need sealing.
How to Install
-
Make sure the lights are powered off.
-
Cut off the extra lights at the desired point.
-
Push the End Cap firmly onto the exposed wire.
The built-in waterproof gel ensures a tight seal. - Secure the end wire with a wire clip to prevent loosening.
Tip: The End Cap is designed for single use only. Replace with a new one if removed.
FAQs
Q1: Do I need to use an End Cap if I didn’t cut the lights?
A1: No. It’s only needed after cutting the light string.
Q2: Can I reuse the End Cap?
A2: No, it’s single-use. Removing and reinstalling it may compromise waterproofing.
Q3: What happens if I don’t use it after cutting?
A3: Water or moisture may enter the exposed end, leading to damage or malfunction.
Updated on 19 Sep 2026
What are your Feelings?
Thanks for your feedback
- Choosing a selection results in a full page refresh.
- Opens in a new window.